6/17/2023 0 Comments Cleanx wipes![]() A two-step process of cleaning prior to disinfection is required only when surfaces are grossly soiled or there is the possibility of contamination with blood or body fluid.Allow cords to dry before packaging the equipment for reuse.Wipe or rinse any residual, after sufficient contact time, if needed.Do not wipe the surface dry prior to adequate contact time.Cords and equipment should not be saturated.If pooling occurs at the cord connectors, allow adequate contact time and then dry the connectors before reuse.Do not allow any solution from the towelettes to drip into the cord connectors.It is sometimes necessary to wring out the towelettes to avoid excess fluid on the cables. Start at the connectors and wet down but do not saturate the cables while wiping away from the connectors.This permits easy separation of cloths at perforation. Pull cloth wipe from the container at 90 ° angle making certain to position the wipe between the two pointing arrows appearing on the lid.CleanCide Wipes are for cleaning surfaces only, not for use on skin. ![]() Procedure for Cleaning and DisinfectingUsing Wexford CleanCide WipesOn Equipment and Cords Keep small center cap closed to prevent moisture loss from container.Wipe or rinse any residual, after sufficient contact time, from shiny surfaces if needed. ![]() Although the surfaces may appear dry, there is still dampness or moisture present. Wexford disinfectants contain humectants which evaporate slowly to prolong drying time. Unfold cloth and wipe surfaces until visibly wet.Pull cloth wipe from the container at 90 ° angle making certain to position the wipe between the two pointing arrows appearing on the lid. This permits easy separation of cloths at perforation.Wear a cover gown and face protection in addition to gloves if cleaning up a large body fluid spill. ![]()
0 Comments
Leave a Reply. |